H1-0ZBPI-16FU2Q PUMP

These series of stainless steel pumps feature a unique one piece volute casing that are produced using an advanced computer controlled plasma stamping system that ensures total quality control during manufacture (up to 65-200/22). With the smooth surfaces of stamped stainless steel, this results in consistent high standard products, of superior quality and high efficiency.

FEATURES

Stainless steel liquid end components
maximum liquid temperature 110 C
Minimum liquid tenperature -10 C
Stub shaft design
FL = B5 flange mount motor
F & FL = B35 foot & flange mount motor
High quality; corrosion resistance.
Manufactured in Stamped 316L and Cast 316 in larger models
High quality mechanical shaft seals and o-rings
Fitted standard with SiC/SiC/Viton mechanical seal.
Standard IEC motors used
Allowing for single phase, special enclosure, or specific brand motors to be fitted.
Close coupled design
Saves space; simplifies maintenance and installation
Back pullout construction
Assembly and overhaul of the impeller and seal without disturbig suction and discharge connections
High operating efficiency
Lowers operating cost
Top centerline discharge and foot support under casing
Ensures self-venting and reduces misalignment from pipe loads